Vernon Dede

Comments:

As you can see from the build pictures, the sheet metal work includes enclosing the tank tunnel on the frame, building up the seat pan area to recess the seat, flairing the frame and seat to the rear fender and molding in the LED tail light.
There is less than 100 miles on this bike, not even a tank full. We finished the bike 2 days before the Easyriders Bike Show 2006 in Dallas (first two pictures). Started for the first time the day after the show. It was great!!!
Anyway, the bike is brand new.
Our next plans are to build two bikes together. We each want to build a Bobber. He has some ideas for his and I have ideas for mine.
HOWEVER, THE BOSS (my wife) SAYS WE HAVE TO SELL THIS ONE FIRST!!!
There's a lot of good memories with this one, I hate to see it go.
Please, serious inquiries only.

Contact Information
Vernon Dede
vernon@fasteningconcepts.com
Phone: 817-354-7876
Cell Phone: 817-915-8388

Model	2005 Redneck Engineering "Gettin High"
Owner	Vernon Dede
Frame Specs	single downtube
Up::	4
Out::	5
Rake::	40
Gas Tank	5" stretch Independent Gas Tank
Rear Fender	russ weirmont
Front Fender	Milwaukee Iron Front Fender
Front End	6 Deg Rake Mean Street Triple Trees
Length::	6"over
HandleBars	Custom Cycle Controls
Engine	Revtech 110
Trans	Revtech 6-Speed Transmission
Primary	BDL 3" Open Belt Drive
Exhaust	Martin Brothers, Medustas with heat shields
Front Wheel	RC Components "Warlock"
Front Tire	Avon 80/90-21
Front Brake	Hawg Halter front
Rear Wheel	RC Components "Warlock"
Rear Tire	Avon 250/40-18
Rear Brake	Exile Sprocket Rotor rear
Paint	AIREA 5150